MakerFocus ESP32 LoRa 32 (V2), ESP32 Development Board W I F I Bluet ooth LoRa Dual Core 240MHz CP2102 with 0.96inch OLED Display Included 868/915MHZ Antenna for Smart Cities, Smart Farms, Smart Home

Product Details

W I F I Kit series is the new development cost-effective networking program of our company, the main chip using Lexin ESP32,

Tensilica LX6 dual-core processor, clocked at 240MHz, computing power up to 600DMIPS, chip built-in 520 KB SRAM, 802.11 b / g / N HT40 W i-F i transceiver, baseband, protocol stack and LWIP, integrated dual-mode Bluet ooth (traditional Bluet ooth and BLE low power Bluet ooth).

This product is based on the W I F I Kit 32 added SX1276 chip, that is, LoRa remote modem, 868/915MHz frequency, about -139dBm high sensitivity,

+20 dBm power output, high reliability, transmission distance (measured open area communication distance 2.8Km). Onboard 32MByte Flash, W i - F i antenna, 0.96-inch blue OLED display, lithium battery charging circuit and interface,

CP2102 USB to serial chip, the perfect support for Arduino development environment, can be very simple and fast for program verification and product development

Specification

Operating voltage: 3.3V to 7V

Operating temperature range: -40 ° C to + 90 ° C

Supports Sniffer, Station, softAP and W i - F i Direct modes

Data rate: 150 Mbps 11n HT40,72 Mbps 11n HT20,54 Mbps 11g, 11 Mbps 11b

Transmit power: 19.5 dBm 11b, 16.5 dBm 11g, 15.5 dBm 11n

Receiver sensitivity up to - 139 dBm

UDP continues to throughput by 135 Mbps

Antenna

Connector type: ipex

Band definition: 868-915MHz

Standing wave ratio: ≦ 1.5

Gain: 3dBi

Maximum power: 10W

Input impedance: 50Ω